Workbench Height

When setting up workbenches, the height is generally figured at about hip pocket high. But before you buy or build a workbench, consider the height of your tablesaw. If the bench is the same height as the saw it can then be used for extra support when sawing over-size materials.
Read More

Painting Temperature

When using latex be sure that the temperature is above 50 degrees F. It is difficult for latex to form a film at lower temperatures. With solvent-borne paint, be sure the temperature is at least 5 degrees above the dew point. If it isn't, water may condense on the surface as it cools while the solvent evaporates, causing an uneven blushing effect.
Read More

Helping Hand

It seems that for some jobs, you need three hands to get it done. Your pliers can lend you that extra hand. Use the pliers to grip the wire or small piece you need to have held. Then wrap a rubber band around the handles to maintain the grip while you complete the work.
Read More

Blade Reverse

If, when mounting a bandsaw blade, the saw teeth are pointing up instead of down, don't panic. Chances are that the saw blade got twisted inside out as it was uncoiled. To remedy, just twist the saw blade right-side out and it will mount correctly. Watch for this, especially when you are mounting a metal-cutting blade which has small teeth. If used upside down it will cut poorly and the teeth can lose their edge quickly.
Read More

Blade Storage

Saw blades should be stored separately. Keep each blade secured between two pieces of plywood, fastened together by a nut and screw that goes right through the center of the blade. Blades that are chipped, bent or in any way damaged are discarded at once.
Read More

Biscuit Joints

Using thin wood wafers called biscuits can strengthen wood joints by providing more glue bonding area. You can use a biscuit joiner (also called a plate joiner) to cut precision mating slots in boards for the biscuits, which are available in three sizes. Or, to save money you can buy a kit to convert either your router or right-angle grinder. The conversion kits will generally cost about half that of a dedicated biscuit joiner.
Read More

Blade Height

Before turning on your table saw, make sure that the height of the saw blade is no more than 1/2-in. and no less than 1/8-in. above the surface of the workpiece. When setting the height of your table saw, you want to balance the need for safety with effectiveness. The goal is to leave as little exposed blade as possible while still being able to cleanly saw through the wood. When too much of the blade is exposed above the workpiece, friction is increased and the chance of chipping is greater. Also, the higher the blade height, the greater the severity of injury.
Read More

Blade Check

If your wood gluing work is less than successful, check your blades. If the blade in your saw is getting dull, it can loosen (but not remove) a layer of fibers on the edges to be joined. Later, glue may not be able to penetrate through this debris to solid wood, resulting in weak joints. A signal that this may be the problem is if ruptured joints are coated with fibers.
Read More

Blade Breaks

If a bandsaw blade breaks, it can be brazed or welded. But check for the cause. The most common causes include: 1) misalignment or adjustment of the guides, 2) either forcing or twisting a wide blade around a curve, 3) feeding in the work too fast, 4) dull teeth or not enough tooth set, 5) excessive tightening of blade, 6) top guide set too high above work being cut, 7) using a blade with improperly finished braze or weld, and 8) continuously running the blade when it is not used for cutting.
Read More