When buying quantities of standard fasteners, such as screws or bolts, buy a full box anytime you will need close to a half box or more. The second half of the box will be virtually free. For example, 45 individual screws will usually cost about the same as a box of 100 screws.
As a rule, you should fertilize at least three times a year; spring, summer and early fall.
When you reorganize your basement or garage, buy yourself a number of cardboard boxes all the same size instead of scrounging various-sized used boxes. This way they will all have covers and you can stack them neatly. Mark each box with a big letter and number, like A-1, A-2, etc., on all four sides and top. Use a three-ring binder to write down the box number and its contents.
When drilling blind holes in iron or steel, fine metal bits usually fall into the hole. To remove them, you can use a strong magnet and a soft iron or steel rod that is smaller in diameter than the hole. Push the rod to the hole bottom, then press the magnet to its upper end. Keeping the magnet to the rod, pull it out of the hole and brush away the bits of metal. Repeat until all of the metal bits are removed.
When laminating, use 1" vinyl blind slats between your surfaces to align the edges.
Having a trigger-type oil-can close to your drill press is handy when drilling metal. To make oiling more convenient, find a container that will hold an oil-can that you have available. Then cut two small slits in the upper part to accept a worm-gear hose clamp. Slip the clamp strip into one of the holes and out the other. Then wrap the hose clamp around the post of your drill press, about 5 in. down from the upper assembly. Drop the oil-can into the holder. From then on oil will always be just an arm's reach away.
Periodically check your levels for accuracy. If dropped or bumped they can get jarred and out of alignment and ruin a project. Compare two or three levels at once to be sure.
A way to get a good fit when installing decorative molding is to install the first piece with a square end. Then cut the second piece at a 45-degree angle in a miter box or saw to expose the profile. Use a coping saw and follow the edge of the profile, under-cutting it about 3 degrees. This lets you get a good fit, even if the corner is not perfectly square.
When you finish your next project, instead of throwing away unused building materials, donate them to a non-profit organization and let someone else put them to a good use.
Shavings can pile up around a hole being drilled, making it hard for you to see what you are doing. To prevent this, push the point of the drill bit through a 4-in. strip of masking tape, then draw the tape up the bit so it will clear the work. Fold the strip lengthwise to bring the sticky sides together. The tape "wings" will act as a fan to clear the surface.