If your planning a backyard pond, locate it where it is unlikely to attract unattended children. Check local safety ordinances to determine if a fence is required for the specific depth and size of your pond. Check local building ordinances for depth and safety restrictions and permits. Equip outdoor outlets with a ground-fault circuit interrupter. Unplug the pump before cleaning the filter.
Turn your water heater down to 120 degrees Fahrenheit to save money on your gas/electricity bill. If you have children in the house, this is also a safety measure.
Bent nails often result from poor hammering technique. However, they can also be caused by a dirty hammer face, especially when using cement-coated nails or working around adhesives. If you have problems, occasionally run a piece of fine sandpaper or emery cloth over the face. If you keep the face clean you will gain more solid contact with the nail and will avoid black marks on the wood caused by a dirty hammer.
If you are about to start a carving or turning project, don't take wood from cold outside temperatures into your shop with high heat and low humidity and immediately start working on it. Give the wood a chance to equalize with your shop's climate, preferably for at least two weeks. Also don't leave large areas of end grain exposed to heat and low humidity. If the project can't be completed through a final finish, use some type of temporary sealer, such as paste wax or shellac, which can easily be removed before finishing.