> Ask a Question > Fix It Forum > Z bar..
Login | Register

Z bar..

Posted by Steve: on July 3rd, 2001 07:00 PM
In reply to Installing z bar carpet strip by Eric on July 3rd, 2001 01:51 PM [Go to top of thread]

3 of 5 people found this post helpful

there should be a combination of teeth and a curved edge that holds and grabs the carpet. Normally, I use a putty knife to push the carpet over the teeth then carefully hammer down the curve area to bit the carpet.

The difficult part is to make sure the Z bar is properly attached to the cement if you have a slab, if wood, no problem at all.

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC