> Ask a Question > Fix It Forum > With your circular saw
Login | Register

With your circular saw

Posted by Moderator, Steve on December 11th, 2002 06:08 PM
In reply to peg board by Meret Lenzlinger on December 11th, 2002 04:49 PM [Go to top of thread]

rip some furring strips just wide enough for the peg back end to enter and turn. You will have to measure the min clearance.

Also, something else that works great. You know those plastic gutter ferrels? With a hax saw, they make super spacers. On the ends of the peg board, line up a hole and line up the center of the sawed off plastic thing and send a screw down that alley and its done.

Was this post helpful? Yes: or No:

Topic History:

  • peg board by Meret Lenzlinger  12/11/02 04:49 PM

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC