> Ask a Question > Fix It Forum > Try this
Login | Register

Try this

Posted by Moderator, Steve on February 19th, 2002 07:07 PM
In reply to CUTTING ANGLES by BRONSON on February 19th, 2002 03:55 PM [Go to top of thread]

get some nice flat pieces of cardboard. Get an Exacto Knife and make a template of the cardboard and then once good and tight, transfer that to the actual plank.

You can also do some intricate measurements and get a good long armed compass and then determine your angle and then measure it out.

There are a ton of ways to do this, but over the Internet, the best way is to make a good template.

Was this post helpful? Yes: or No:

Topic History:

Topic Follow-ups:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC