> Ask a Question > Fix It Forum > trimming door
Login | Register

trimming door

Posted by bc on October 19th, 2000 12:41 AM
In reply to Trimming a door. by Ed on October 18th, 2000 07:32 PM [Go to top of thread]

You should be allright. I have seen them with different sized stock on the edges though. Sometimes cutting too much will show a tenon and mortise joint. Remove the door knob and latch to see how thick it is on that side and check the screw holes on the hinge side. Also if not prehung or predrilled yet, then just get an 1/16" inch bit or so and drill a small hole around a hinge or knob area. Measure the depth you drill through for the thickness.

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC