> Ask a Question > Fix It Forum > support
Login | Register


Posted by Steve: on January 4th, 2002 08:15 AM
In reply to floor support by tom on January 4th, 2002 07:40 AM [Go to top of thread]

the 2x6 blocks will work well, and screw down the floor every 8 inches in the area and surrounding area of the washer this will stop all bouncing also.

I would speculate only, that the bounce is NOT the joists, but the sub flooring and flooring not being properly fastened to the joists in that area and especially if the washer is in an in balance mode while spinning.

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC