> Ask a Question > Fix It Forum > Sensor and board
Login | Register

Sensor and board

Posted by Harold on October 7th, 2002 10:57 AM
In reply to Payne Furnace Problem by John Wessels on October 7th, 2002 08:54 AM [Go to top of thread]

When there is a problem in the ignition sequence, many boards reset by having the power turned off for 30 seconds, then on again. This could be as simple as a bad ground, dirty or mislocated sensor, or as bad as an incorrect draft, or needing a new circuit board.

Was this post helpful? Yes: or No:

Topic History:

Topic Follow-ups:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC