 |
Sear's Water Softner Mod.# 625.348300
Posted by Ed Malone on April 12th, 2004 07:30 PM
My Sear's Water Softner Mod # 625.348300 will not draw salt brine during regeneration. I have cleaned the entire injector unit including the red and clear tubes, the tube and foot valve in the brine tube, and the brine tank. During the brine cycle there is no suction on the brine tube. Also checked and replaced valves. All other function seem normal. Any suggestions for a solution to the problem? Was this post helpful? Yes: or No: |
 |
Post Reply
Watch this Post
