> Ask a Question > Fix It Forum > roll pin removal
Login | Register

roll pin removal

Posted by pete on February 23rd, 2003 08:56 AM
In reply to Repairing Garage Door Opener by Chris on February 1st, 2003 01:19 PM [Go to top of thread]

1 of 2 people found this post helpful

Moderator Post:
> Garage Door Issues by Handyman on 02/16/2005

Hi Chris,
I am assuming it is a split pin going through a gear and shaft. Go to the hardware store and buy a punch that is specially made to drive out roll pins(it will have a small ball at the tip). This punch must be slightly smaller than the hole through the gear and shaft. Line the punch up with the roll pin and use a hammer(wear safety glasses) to drive out the pin.
that should work........pete

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC