Rockwell Model 34-695 Homecraft 10 inchTable saw.

Posted by John Garrett on November 18th, 2003 03:49 PM
In reply to Delta/rockwell parts by Bill on January 21st, 2001 11:03 PM [Go to top of thread]

Moderator Post:
> Parts for Rockwell/Delta Table Saw/Joiner by RYWben on 04/13/2011

I am looking for a manual and somewhere where I can get parts for my Rockwell Model 34-695 10 inch Homecraft Table saw.

The part I need is the Nylon gear which controls the Blade angle. about half the teeth are sheared off.
I can raise the blade up and down but cant miter unless I manualy reach up inside the saw to push the
blade.
I have no idea when this saw was manufactured but I am guessing soemtime in the 60's?

Any help would be appreciated

Was this post helpful? Yes: or No:

Topic History:

Delta/rockwell parts by Bill 1/21/01 11:03 PM (: 30, : 19)


	The Webmaster has closed this topic to new posts. Please see the �Most Relevant Post� as suggested by the forum Moderator or go to top of topic for a full history of this topic as it may have been answered. We also recommend searching other topics to see if your question has been answered or starting a new topic.