renovateyourworld.com > Ask a Question > Fix It Forum > outside corner crown moulding angle settings for miter
Login | Register

outside corner crown moulding angle settings for miter


Posted by Troy Studly on December 17th, 2002 06:32 PM
In reply to cutting crown moulding by bob on March 1st, 2001 01:39 PM [Go to top of thread]

Dear Bob,
I'm am in the final stages of completing my kitchen remodeling project, but cannot for the life of mefigure out these last cuts. The 45 degree angle the crown moulding sits at doesn't seem toallow me to make the standard 45 degree cut for the outside corner. If this is understandable from my message, could you please reply with the appropriate angle settings.
Thank you, Troy Studly

Was this post helpful? Yes: or No:

Topic History:





About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC