> Ask a Question > Fix It Forum > no lighting
Login | Register

no lighting

Posted by Harold on December 17th, 2002 11:50 AM
In reply to Janitrol burner stops lighting by Carey on December 17th, 2002 08:49 AM [Go to top of thread]

Check all wires for good contact, clean the sensor, make sure all terminals are tight, check to see if the draft switch is under good conditions, make sure your 115-volt wiring polarity is correct, be sure you have a good ground. Observe, if all is proper, then you might need the board.

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC