> Ask a Question > Fix It Forum > nailing crown molding
Login | Register

nailing crown molding

Posted by Robert Goldthwaite on September 26th, 2001 10:48 PM
In reply to crown molding help by Sam Jones on January 9th, 1999 05:04 AM [Go to top of thread]

0 of 1 people found this post helpful

Moderator Post:
> Mitre Cuts and Crown Molding by Handyman on 05/19/2005

Take a 2x2 pine and cut it in 2 length wise on your table saw with the blade set at 45 degrees
You will now have two triangular corner nailers.
lag these into the corner of wall and ceiling with 3" screws and a screw gun. Use them for nailing your crown. You can put a small finish nail anywhere on the molding then nailset and fill.

Was this post helpful? Yes: or No:

Topic History:

Topic Follow-ups:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC