> Ask a Question > Fix It Forum > Motion sensors
Login | Register

Motion sensors

Posted by Rick White on August 27th, 1999 10:32 AM

I'll try this again...since no one answered my first
I have recently installed 2 motion sensor lights,
one with flood lamps, and one deco fixture over a front door.
The one over the front door has instructions that
say it can be wired to another motion sensor light
using an additional "red wire" to the black wire.
Both motion sensor lights are connected to a common
light switch. One is supposed to be "master" and one
is "slave". The problem is, I can't get the "master"
to work! It stays on all the time. The flood light
sensor works fine. Both lights have separate motion
sensors. They are both set to one minute time-on.
If I disconnect the "red wire", the flood motion
sensor does not work. They both require 1 1/2 minutes
to "calibrate". They are made by Heath and Heath/Zenith.
What am I doing wrong?
Please answer me..thumbs up or down..ok?

Was this post helpful? Yes: or No:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC