renovateyourworld.com > Ask a Question > Fix It Forum > looking for 1/8 in. slotted and No. 1 Phillips offset screwdriver to remove windows hardware
Login | Register

looking for 1/8 in. slotted and No. 1 Phillips offset screwdriver to remove windows hardware


Posted by Manny on May 24th, 2002 01:18 AM

I am looking to replace my anderson type windows hardware and the opening where I must work to remove the old phillip screws is very small. I have tried the # 1 & # 2 Phillips x 1/4-IN offset screwdrivers (the L shaped screwdriver) but is a fraction too big. I want to know if there are any smaller screwdrivers, perhaps a # 1 Phillips 1/8-In Offset Screwdriver?? And if there are, where can I get them?

I have also purchased a KAStar 5-piece offset reversible ratcheting screwdriver bit wrench set, but the phillips bits are 1/4" and is a fraction too big. Are there smaller bits, perhaps a 1/8" available?

Your help on this matter is greatly appreciate it.

Was this post helpful? Yes: or No:

Topic Follow-ups:





About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC