> Ask a Question > Fix It Forum > Knee Wall molding
Login | Register

Knee Wall molding

Posted by Bruce M on December 31st, 1997 11:45 PM
In reply to Molding by Dave Bean on December 29th, 1997 03:59 PM [Go to top of thread]

Hi Dave:
I was not able to find a standard molding for my attic knee wall, so I measured the angle and found it to be about 40 degrees, which is close enough to use a small crown molding. Otherwise, I would have angle ripped a straight piece of 2X2 at the correct angle, then cut a decorative edge on the exposed part.

There are many ways to do this to cover up that odd angle at the top of the knee wall, and have that joint look reasonably nice.

Take care

Bruce M

Was this post helpful? Yes: or No:

Topic History:

  • Molding by Dave Bean  12/29/97 03:59 PM

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC