> Ask a Question > Fix It Forum > It should
Login | Register

It should

Posted by Moderator, Steve on April 6th, 2003 09:24 AM
In reply to refinishing hardwood with polyurethane by Mike Petix on April 5th, 2003 07:45 PM [Go to top of thread]

remember, if oil, poly will not stick to itself without light roughing up sanding. I would work on that area slightly and feather it out. Then apply your poly to that area again feathering out to make a nice blend in with the surrounding area. Depending on how deep the print is, will tell how many coats will be needed to even it out. Always remember to feather it out and keep the coats thin.

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC