> Ask a Question > Fix It Forum > inside crown mitre cuts
Login | Register

inside crown mitre cuts

Posted by Mac on July 8th, 2002 09:41 PM

well I have a problem- I am installing some 52/38 crown moulding on a movie set, and so I downloaded a chart that tells me the correct mitre and bevel angles to use. This has worked very will until now- I have to put some crown on an inside corner- 45 deg. My chart begins at 67 deg and goes to 179 deg - and I think that I need it to go down to 45 deg, but I am not sure- Now the outside 45deg corners worked fine, (135 deg) the mitre on that one was 14.3 deg, and the bevel was 17.55 deb, so I tried that for the inside corner- not even close!!! trial and error brought me to believe that it may be close to 75 deg but I am not sure- so is there a chart that goes down to 45 deg?? or am I reading this chart wrong?? I have to get this stuff installed tomorrow morning at 6am, so I am in a bit of a pinch here :):)

thanks for the help :)


Was this post helpful? Yes: or No:

Topic Follow-ups:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC