> Ask a Question > Fix It Forum > Inlay (Abaloni and Mother of Pearl)
Login | Register

Inlay (Abaloni and Mother of Pearl)

Posted by George Jacobson on September 17th, 2002 02:45 PM
In reply to scroll saws by tom pierson on January 14th, 2000 09:08 AM [Go to top of thread]

I would like to cut (w/ a scroll saw) thin .030 to .060) Abaloni and Mother of Pearl. This stuff is very fragile and 9 out of 10 times it is usually done by hand with a jeweler's saw. Is there a saw that can cut as fine as a jeweler's s saw so that I can speed up my cutting a little bit and also make it less tedious. I am an older man and I would beable t oafford a very high quality saw but it must beable to cut fragile materials. Do you have any sugggestions as to what to purchase? I am not familiar with scroll saws so I do not want to buy the wrong saw. My work will be approx. 95% in the area mentioned above.
George Jacobson

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC