> Ask a Question > Fix It Forum > I asssume the oven still works
Login | Register

I asssume the oven still works

Posted by LJ in TX on November 22nd, 2002 02:29 PM
In reply to Maytag Oven by jamie on November 22nd, 2002 01:39 PM [Go to top of thread]

otherwise. what you need is a schematic or diagram of the board to see where the beeper is located.......what was the purpose of the beeper? is the funtionallity of the oven going to be affected if you disable the beeper? maybe you can jumper across the membrane switch or clip one end of the switch to stop the signal or power feed to the beeper. too assuming you new what it looked like. did they show you one at the parts store? good luck LJ

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC