renovateyourworld.com > Ask a Question > Fix It Forum > Glad It Worked Out OK.....
Login | Register

Glad It Worked Out OK.....


Posted by Dodgeman on November 24th, 2002 04:39 PM
In reply to Dodgeman by Vince on November 24th, 2002 02:20 PM [Go to top of thread]

I have had the same problem with some of the screws not going flush or slightly below the surface. If they are sticking up less than 1/32 inch, the mortar will compensate. If they are sticking up more than 1/32 inch or so, then back them out a few turns with your power driver, and run them down again.
Good Job!
Dodgeman

Was this post helpful? Yes: or No:

Topic History:





About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC