> Ask a Question > Fix It Forum > Formica
Login | Register


Posted by Jeff on January 29th, 2003 01:07 PM
In reply to finishing formica surfaces by Jeremy Adams on January 29th, 2003 10:26 AM [Go to top of thread]

Use a jigsaw with a fine-tooth blade to trim the formica to a size roughly 1-2 inches larger than your surface all the way around. After applying contact adhesive to your stock and your formica, place the formica over the stock using dowel rods to keep them separate. Center your formica over the stock and remove the rods one by one. After the formica is completely attached, roll it or gently 'smack' it with a rubber mallet. Next, trim to nice finished edge with a flush bit router (make sure it is carbide tipped and really sharp!).

Was this post helpful? Yes: or No:

Topic History:

Topic Follow-ups:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC