> Ask a Question > Fix It Forum > flex duct
Login | Register

flex duct

Posted by Harold Kestenholz - Hydronic Network on November 22nd, 2001 11:23 AM
In reply to Adding extra heat registers in finished basement ceiling by Mike in Ypsilanti, MI on November 21st, 2001 10:51 PM [Go to top of thread]

If this duct is for heating only, you can attach aluminum flex duct to the flat duct with a round takeoff after you cut the hole out. Like dryer vent duct it pulls out from a slinky-like compression in the box to a longer piece.

You can slip an insulation sleeve over the duct. Insulated plastic flex duct can slip through as well.

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC