> Ask a Question > Fix It Forum > Edge metal
Login | Register

Edge metal

Posted by David on April 15th, 2003 09:37 PM
In reply to Carpet by Terry Franks on April 15th, 2003 02:13 PM [Go to top of thread]

Terry, 1/8th inch is fine; mark the floor for holes then set the metal aside & drill your holes(even using a larger bit if you wish, the drive the holes full of shim wood or glued dowel & nail the strip down.

Was this post helpful? Yes: or No:

Topic History:

  • Carpet by Terry Franks  4/15/03 02:13 PM

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC