> Ask a Question > Fix It Forum > Driver bits wrong size
Login | Register

Driver bits wrong size

Posted by Gary Lewis on February 25th, 2003 06:16 PM
In reply to Driver Bits by Mr Lowes on February 14th, 2003 08:59 AM [Go to top of thread]

The hex on the driver bits included with the Deckmate screws seems to have a undersize hex. I used these in building a shed where I didnt want rusty screws. I use a magnetic bit holder to retain the screws on the bit but the holder is retaining the bits instead. After driving a few screws the bit has twisted out of position in the holder and I can not pull it out. I now have two bit holders with these special bits permantly embedded. I suppose I could try torching them out. Any feedback on this? Has anyone else experienced this?

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC