> Ask a Question > Fix It Forum > Cutting an inside corner
Login | Register

Cutting an inside corner

Posted by EdF on December 27th, 1999 08:18 AM
In reply to inside corner cut on laminates by don germano on December 24th, 1999 11:24 AM [Go to top of thread]

I assume you'll be cutting the laminate, then gluing it in place. So here goes...
1) Measure, draw a template (if possible), measure, measure, and measure
2) If the lines to cut are straight, using a GOOD straight-edge, cut with a sharp utility knife. Just take your time and make many passes.
3) Alternatively, you can use a plastic cutting blade in a saber saw. If you decide to do it this way, put some good tape over the area to cut. This will help prevent chip-out (the finer the blade, the better. I've even seen some knife-like blades that would be good).

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC