> Ask a Question > Fix It Forum > Craftsman drillpress "Model 150"
Login | Register

Craftsman drillpress "Model 150"

Posted by Bob Luff on February 12th, 2003 02:21 PM
In reply to Craftsman drill press by callum on January 8th, 2003 10:07 AM [Go to top of thread]

3 of 3 people found this post helpful

Moderator Post:
> Craftsman Parts and AMT 5300 by Handyman on 05/17/2005

Purchased older Model 150 Craftsman drillpress.
Need help in locating manual/ parts# or just info.
1) Something is missing where base (w/front wheels) attaches to main vertial support. With bolt tightened all the way--base and pipe not secure-- what else should be bolt hole?

2) Idler/ pulley ratio wheel is not attached to anything. Does it mount to inside diameter of support tube as it enters up into the top pulley area... or should the support tube not extend so far up the top casting and the idler assembly secure to the inside diameter of the casting hole where the tube would be if allowed to come up that far??

Was this post helpful? Yes: or No:

Topic History:

Topic Follow-ups:

Thread Closed
The Webmaster has closed this topic to new posts. Please see the “Most Relevant Post” as suggested by the forum Moderator or go to top of topic for a full history of this topic as it may have been answered. We also recommend searching other topics to see if your question has been answered or starting a new topic.

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC