> Ask a Question > Fix It Forum > coping joint
Login | Register

coping joint

Posted by Dennis Meyer on December 17th, 2000 09:28 PM
In reply to crown moulding using a compound miter saw by Roxanne on June 12th, 1998 09:34 PM [Go to top of thread]

0 of 1 people found this post helpful

you do not make coping joints with a compound miter saw you use a coping saw. this is an inside corner joint. set your miter saw for just under 90 degrees, after making the cut follow the profile.of the outside edge with our cope saw to remove the backside of the moldingso that it matches the profile of the piece it is fit to.the outside corners are cut on the compound miter saw useing the angles of (mitertable setting of 31.6 degrees) bevel ( tilt) 33.9 degrees

Was this post helpful? Yes: or No:

Topic History:

Topic Follow-ups:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2016 Renovate Your World LLC