> Ask a Question > Fix It Forum > compound agles on the table saw
Login | Register

compound agles on the table saw

Posted by kenneth alsbury on June 20th, 2000 01:59 PM
In reply to COMPOUND ANGLES CUT ON TABLE SAW by dON hOOD on July 20th, 1998 11:18 PM [Go to top of thread]

1 of 1 people found this post helpful

I have the same problem which i overcome by the following method:-
support one of the panels on the saw at the angle it will be at on the final product.
swing the panel to the finished rotational angle.
e.g six sides is 120 degrees so the panel will be at 30 degrees.
raise the saw blade about i eight and cut through the edge of the panel.
measure the resulting angle and that is the tilt
angle of the blade.
now with the panel flat on the table and rotated
to 30 degrees the compound agle is automatic.
good luck, ken alsbury

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC