 |
Chain saw help
Posted by dmw1954 on December 3rd, 2010 02:50 PM
In reply to No master link. Loosen or remove the two mounting nuts for the bar, by Bruno1949 on December 3rd, 2010 01:56 PM [Go to top of thread]
Thank you so much for you well stated information. After reading your reply it appears that the chain wasn't on inside out, I believe, from what you discribed below, it was put on backwards. I am going to take it to a small machine repair shop down the road and have them correct it. i don't want to take any chances. Thanks again for your impute. Was this post helpful? Yes: or No: |
 |
Post Reply
Watch this Post
