> Ask a Question > Fix It Forum > Carpenter cap
Login | Register

Carpenter cap

Posted by Scott on January 22nd, 2003 08:45 PM
In reply to chair rail by Paul Allen on January 22nd, 2003 08:05 PM [Go to top of thread]

I ues this method to end molding where you will see the end exposed.

Cut an outside miter at the point you want to end the run.With round corners(I really like that look)make your outside long point of the miter end right where the curve and flat wall meet.

Cut an opposite outside miter just big enough to fit the exposed end miter.CAUTION this is a small piece so cut it from a piece of trim that you can work with safely.I just glue this piece.Luck

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC