> Ask a Question > Fix It Forum > Burning cut material?
Login | Register

Burning cut material?

Posted by JT on October 22nd, 1997 07:03 PM
In reply to bit by Fred McNulty on October 21st, 1997 05:53 PM [Go to top of thread]

Fred, I'm sure Herrick's words of wisdom will help,
but I'm really curuious here. Did I misunderstand?
I thought you were saying that the buning was along
were the bearing ran. If it's along the cut edge,
that's often due to moving the router too slowly.
Do you have a new router that runs at a higher RPM
than the old one?

Was this post helpful? Yes: or No:

Topic History:

Topic Follow-ups:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC