> Ask a Question > Fix It Forum > Actually
Login | Register


Posted by Tony on December 12th, 1999 10:43 AM
In reply to Turn the water on....... by J.C. on December 12th, 1999 07:42 AM [Go to top of thread]

Actually, in many situations it is much easier to sweat with MAPP than with propane or swirl torches. This is based on the target heat of the gas (1100 F v. 2400 F) and that lead-ree solders melt at a higher temp. And last time I checked the cost difference wasn't that great.

Plus many of the joints I will be working on are in very tight locations. So I was hoping to test them out before I had to do any contortionist moves.

Thanks for the info. Though I have sweated plent of joints. Just not to this scale.

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC