> Ask a Question > Fix It Forum > A solution that worked well
Login | Register

A solution that worked well

Posted by deecee on April 3rd, 2003 11:17 AM
In reply to cypress siding shrinkage by Aynthia on April 3rd, 2003 08:19 AM [Go to top of thread]

for this situation on a cedar home, but which was quite time consuming, was to mask the wood on either side of the gap and apply clear silicon caulking into the gap and then press a LOT of cedar sawdust into the fresh silicon. After a couple of days of curing, each joint was dressed with sharp wood chisel and a bit of rough sandpaper. Came out pretty nice. This job wasn't due to shrinkage. The installer left gaps for expansion that never happened. You might check with the manufacturer of your siding for their ideas. Luck, Kizmet

Was this post helpful? Yes: or No:

Topic History:

About  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2017 Renovate Your World LLC