Spring is a good time to paint fences and the exterior of your home, especially wood surfaces. This way, they will be protected from summer heat and sun. Wood decks should also be sealed once a year.
Our love of gardening oftern begins in childhood. Share your passion for gardening with your child or grandchild and plant the seed for generations to come.
To increase accuracy, some woodworkers avoid using the zero end of a rule or tape and use the 1-in. mark instead. You can also use other starting points, such as 2 in. or 3 in. However, when using this technique, you must remember to subtract that number from the actual reading further down the rule.
A sharp mower blade is a key to a perfect cutting job. However, whenever you sharpen a blade yourself, always check it for balance. An out-of-balance blade can cause excess mower vibration and wear. One way to check is to tie a metal washer onto a string, thread the string through the center hole of the blade, then hold the blade up with the washer supporting it. The washer should be on center and turned perpendicular to the blade. The blade should stay level. If it doesn't, grind it for balance on the back side of the blade. Always disconnect the lawnmower's sparkplug wire before removing or replacing any blade.
Remember that extreme temperatures can build in an attic without proper ventilation, especially with a dark colored roof.
If you plan to refurbish a major shop tool or other equipment, take some photos before you start. They possibly can save you some head-scratching during the reassembly process. Take pictures from a number of angles, and take close-ups of areas where you think you might have some questions later. The more complex the machine, the more photos you should take.
If your wood gluing work is less than successful, check your blades. If the blade in your saw is getting dull, it can loosen (but not remove) a layer of fibers on the edges to be joined. Later, glue may not be able to penetrate through this debris to solid wood, resulting in weak joints. A signal that this may be the problem is if ruptured joints are coated with fibers.
If a bandsaw blade breaks, it can be brazed or welded. But check for the cause. The most common causes include: 1) misalignment or adjustment of the guides, 2) either forcing or twisting a wide blade around a curve, 3) feeding in the work too fast, 4) dull teeth or not enough tooth set, 5) excessive tightening of blade, 6) top guide set too high above work being cut, 7) using a blade with improperly finished braze or weld, and 8) continuously running the blade when it is not used for cutting.
When laminating, use 1" vinyl blind slats between your surfaces to align the edges.
Before you glue up wood for a project, examine the parts. If at all possible, start out with cleanly cut, perfectly straight boards of the proper thickness. Take out any bow or warp before you begin your gluing work. By using straight and true stock, you won't have to force the boards in one direction or another, and you won't have to get into tricky, complicated clamping set-ups.